Black cooker hood splashback for the kitchen

Product information

The black cooker hood splashback is available for dispatch within 2 working days in 60 x 70 or 90 x 70 sizes. Made-to-measure sizes are manufactured to order.

To guarantee your safety and satisfaction for many years to come, PlakGlass only uses quality toughened glass, also known as "Securit" glass, to make your black glass cooker hood splashback.

A protective film is also added to the back. It is therefore heat-resistant and compatible with all hobs, including gas. In the latter case, however, you must make sure to keep a distance of 10 to 15 centimetres from the burner to avoid any close or direct contact with this heat source.

Thanks to its high-quality design and a thickness of 6 millimetres, the black back-painted cooker hood splashback can be drilled (before the glass is toughened in the workshop) to meet all your requirements. Available in gloss, it blends perfectly into your space.

The cooker hood splashback shown here is available in standard sizes, namely 90 x 70 cm and 60 x 70 cm. If you need a different size, our workshop can also make a made-to-measure, customised black cooker hood splashback for you (rounded corners, bevel, etc.). Likewise, if you need a different colour, PlakGlass offers dozens of others in its configurator.

Your black glass cooker hood splashback must only be installed indoors, as the paint used is not designed for outdoor use. Fitting itself is simple, but requires a special mirror adhesive, a silicone sealant for watertightness and small wooden spacers. The adhesive is applied to the painted side in dabs. If there is a hole or cut-out in the cooker hood splashback, place dabs all around it.

Please note that this is a specific adhesive, offered as an option when adding the item to your basket, and that no other adhesive should be used.

Then place the spacers on your worktop so as to keep a gap of no more than 3 millimetres. Apply the black cooker hood splashback. After 24 hours of drying, all you have to do is remove the spacers and seal the joint with silicone.
Your hob splashback is heat-resistant but cannot withstand direct contact with a hot object. Make sure you position it more than 10 centimetres from the flame for a gas hob, ideally 12 centimetres.

Plakglass has long been committed to quality. Our workshop therefore only offers products made with quality toughened glass. This applies to the choice of materials, but also to strict compliance with current environmental and health standards. This last point is far from trivial, as it guarantees you a healthier home, particularly with regard to VOC (Volatile Organic Compound) emissions.

Product care

Looking after a black kitchen cooker hood splashback is simple: a sponge or microfibre cloth, a non-abrasive household product and a dry cloth are all you need.